Can you lay paving slabs on concrete

Create a fountain, pond, or water feature. Use it as pavers to create a terrace or patio. Will Liquid Nails adhere to concrete? Can Gorilla Glue be used on concrete? How do you fix loose pavers on concrete?

But here's a closer look at how to repair loose pavers: Pull out the loose paver and add sand, small amounts at a time. Spread the sand out into a flat layer and then tamp it down. Use a level to make sure it's flat and even. Place the paver in the space and check its height in relation to the pavers around it. Do pavers need to be laid on concrete?

The process is nearly identical to laying a paver patio over ground. Before you begin, make sure your concrete is properly sloped and doesn't puddle. Can you put thin pavers over concrete? Pavers over concrete slabs can be accomplished by installing the thin concrete paver on the perimeter with mortar or thin-set and then screeding base sand inside the perimeter and then installing the thin concrete pavers over the sand base.

What is the best masonry adhesive? Reviews of 5 Best Concrete Adhesive ? How do you make a ceiling swirl? If not, what do you suggest? Thanks, Joe. Another area to consider when making lawns and gardens look great is professional concrete curbing. Curbing will really enhance the look and feel of your property, either residential or commercial.

Installing concrete curbing is what we do and it makes all the difference. The pitch from the middle of the patio has changed and its slopping toward the house and now my laminate floor is warped because of the moisture from the water absorbed by the concrete slab my house is built on. Also, the paver stones by the wall of the house are all lifted up or sunken down.

The question: would almost 19 years of water saturating the patio and the house cause the downward sloping of the patio and the pavers to shift and come up and sink down? The homeowners association is responsible for outside maintenance and the sprinklers and they are trying to shift the responsibility for this issue.

I would appreciate any information you can provide. Dee, I think you need an attorney. I am living testimony to the effects sprinklers can have on on structures. Good luck! I want to put a step outside of my French door. It is paved area. What do I put down first before I lay the bricks and then the paving slabs? I am a lady of 71 and I would like to have a go at this.

Is there a way to drill drainage holes in an existing partically cover patio. The patio is concrete cover with porcelain tiles. When there is a heavy rain, the water puddles in areas and runs across part of the patio.

The patio has a stone wall on one side and the water collects in area against the wall. My landscaper installed pavers over my existing patio using a sand base and filling the spaces between with sand…then the rains came and leached water up to the stucco on the house. They drilled about 60 holes in the patio, layed the pavers over sand again and now the monsoon season in New Mexico is here…needless to say, water is leaching up to the house and staining the stucco….

My landscaper says this is normal and especially on a patio facing north. I say this could ultimately result in stucco damage as well as other structural problems…any suggestions? I have cool deck over concrete around my pool. It is not is bad shape but looks old. What is the best way to spruce this up and make it look new again? I have an uncovered patio that used to have outdoor carpet.

After mulitple demo efforts, there are still traces of carpet glue residue and water pools in the center. The patio is surrounded by the brick walls of our house on three sides and a short drivet wall on the fourth. I am open to removing the short wall. Lay the paving slabs, leaving 8 to10mm spaces between them 5.

Fill the joints with the mortar mix and leave to set. Check for any flaking or loose bits and remove them. Spread a cement-based priming product on to the back of the slabs. Using four parts sand to one part cement and water, create a mortar mix. Take care to add just the right amount of water for a firm consistency — it should be damp, but not wet and runny. Put down a 30mm layer of the mix and ensure you have an even, smooth base, ready for your slabs.

Put the finishing touches to your project by using the mortar mix to fill in the spaces between the slabs. Prefer to have your patio installed by an expert? Get in touch today or click here to find your nearest Marshalls-accredited installer. Subscribe to our newsletter now and keep up to date on our latest products, advice and helpful guides. Home Blog How to lay a patio on concrete Mobile parent link Blog. How to lay a patio on concrete Darius Negahbani Tuesday 2nd January, Tags garden how laying patio to.